The FA-Series Handlesets are an excellent choice for use on residential single and multi-family entrance doors. The interior half of the handleset is comprised of wrought brass.

Exceeds ANSI Grade 2 standards. Two piece interior trim set may be combined with an exterior handleset, see related products. All handleset designs have an adjustable through-bolted for added security, and easy installation. Through-bolt can move up and down 1½ inches to fit a variety of pre-existing holes. Lifetime Limited Finish and Mechanical Warranty. Door range: 1-5/8 to 2 inches thick standard. Backset: Adjustable from 2-3/8 or 2¾ inches standard. Required door preparation: Two 2-1/8 inch cut-outs and two 7/8 or 1 inch edge bore holes. Holes must be on 5½ inch center.

Note: This is one half of a complete handleset, F or FA-Series Exterior Handleset must be purchased separately, see related products. Screws, strike and locking mechanism is included with interior portion of handleset. For non-standard set requirements please contact our sales department to order.

Door Hardware Planning & Measuring Guide

Uncoated finishes are "living" and may wear off over time.

Oil Rubbed Bronze is considered a category "B" finish by ANSI/BHMA and will vary in color when applied to different alloys and forms of base material. ORB will also vary from the production lot and additionally from one manufacturer to another. ORB will wear off over time due to the "rubbed" finishing method that has no protective coating or plating.